Filter
Top Products
13
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse dialing, you can still use these spe-
cial tone services by following these
steps.
1. Be sure
MODE
is set to
PULSE
.
2. Call the service’s main number.
3. When the service answers, press .
Any additional numbers you dial are
sent as tone signals.
4. When you hang up, the phone auto-
matically resets to pulse mode.
MEMORY DIALING
You can store up to 20 phone numbers
and names in memory, then dial a stored
number by entering a two-digit memory
location number. Each number can con-
tain up to 16 digits.
1. Set
NORM/STORE
on the right side
of the phone to
STORE
.
2. Press the line button for an available
line.
3. Lift the handset or press
SPEAKER
,
then press
MEMORY
.
4. Set
VOLUME
to the middle setting,
then enter the number and any tone
and pause entries (see "Using Tone
Services on a Pulse Line" on this
page and “Entering a Pause” on
Page 14).
Note:
Each tone or pause entry us-
es one digit of memory.
5. Press
MEMORY
, then enter a two-
digit memory location number (01–
20).
6. To store additional numbers, press
MEMORY
again, then repeat Steps 4
and 5.
VOLUME
MIN
MAX
LINE 1- RINGER - LINE 2
OFFLO HI
OFFLO HI
MODE
PULSE - TONE
NORM - STORE
VOLUME
MIN
MAX
LINE 1- RINGER - LINE 2
OFFLO HI
OFFLO HI
MODE
PULSE - TONE
NORM - STORE
VOLUME
MIN
MAX
LINE 1- RINGER - LINE 2
OFFLO HI
OFFLO HI
MODE
PULSE - TONE
NORM - STORE
43-652.fm Page 13 Friday, August 13, 1999 11:00 AM