Filter
Top Products
7
3. Plug the supplied AC adapter’s barrel
plug into the
DC 12V
jack on the back
of the base.
4. Plug the adapter into a standard AC
outlet. The IN USE/CHARGE indica-
tor lights when the keypad is on the
base.
5. Lift the base’s antenna to a vertical
position.
CONNECTING AND
CHARGING THE BATTERY
PACK
The ET-548 comes with a rechargeable
nickel-cadmium battery pack in the re-
mote keypad. You must connect and then
charge the battery pack for at least 15
hours before you use it the first time.
1. Use a Phillips screwdriver to remove
the screw that secures the battery
compartment cover, then remove the
cover.
2. Slide the battery pack’s connector
onto the connector pins inside the
battery compartment.
3. Replace the cover and secure it with
the screw.
4. To charge the battery pack, place the
remote keypad on the base. The IN
USE/CHARGE indicator on the base
lights.
Illustration
Illustration
Illustration
43-1048.fm Page 7 Tuesday, August 17, 1999 12:45 PM