Filter
Top Products
11
OPERATION
MAKING AND RECEIVING
CALLS
Before using the phone, put the headset
on and adjust it as needed. Then set
POWER
to
ON
.
To make a call, press
TALK/HANG UP
.
You hear a dial tone and the TALK/LOW
BATT. indicator lights. Dial the number
you want to call.
To disconnect a call, press
TALK/HANG
UP
or place the keypad on the base.
To answer a call when the keypad is on
the base, pick up the keypad. The TALK/
LOW BATT. indicator lights.
To answer a call when the keypad is not
on the base, press
TALK/HANG UP
. The
TALK/LOW BATT. indicator lights.
Notes:
• To conserve battery power, set
POWER
to
OFF
when the remote key-
pad is away from the base. When you
hear another phone on the same line
ring, set
POWER
to
ON
and press
TALK/HANG UP
to answer the call.
• When you press a button, a single
tone indicates that the phone accepts
the command. Three tones indicate
that you pressed a button in error, you
are out of range, or there is too much
interference. If there is severe inter-
ference, move the remote keypad
closer to the base before you press
any key.
• If interference is severe, the remote
keypad might lose communication
with the base and the call might dis-
connect. This does not happen often,
but if it does, return the remote key-
pad to the cradle for a few seconds.
Illustration
43-1048.fm Page 11 Tuesday, August 17, 1999 12:45 PM