Filter
Top Products
6
If you have two separate one-line
modular jacks, plug one end of the
supplied two-line long modular cord
into
L1 or
L1/L2
and plug the sup-
plied one-line long modular cord into
L2
.
3. Insert the supplied AC adapter’s
barrel plug into the
DC 9V
jack on
the back of the phone.
Caution:
You must use a
Class 2 power source that
supplies 9 volts DC and
delivers at least 150 mA. Its center
tip must be set to negative and its
plug must fit the TAD-469's
DC 9V
jack. The supplied adapter meets
these specifications. Using an
adapter that does not meet these
specifications could damage the
TAD-469 or the adapter.
DC 9V
!
4. Route the adapter’s cord through
the strain relief slot on the back of
the phone.
5. Insert the bracket’s two small tabs
into the matching slots at the upper
left on the bottom of the phone, and
snap the large tab of the bracket into
the large slot at the upper right.
6. Connect the other end(s) of the
phone cord(s) to the phone line
jack(s).
Strain Relief Slot
43-469.fm Page 6 Tuesday, January 19, 1999 9:48 AM