Filter
Top Products
11
Operation
• Press
1
to enter a space between
names.
• If you are using two consecutive let-
ters that reside in the same number
key, press
FUNC
between the letters.
For example, for “Tammy Smith,”
enter
8 2 6 FUNC 6 999 1 7777 6 444 8
44
.
5. Press
MEM
again.
;DJ;Hý J;Bý DKC8;H
;DJ;Hý J;Bý DKC8;H;DJ;Hý J;Bý DKC8;H
;DJ;Hý J;Bý DKC8;H
appears.
6. Dial the desired number (up to 24 dig-
its).
7. Press
MEM
again to store the number.
The handset sounds two long beeps.
Note:
If you hear three short beeps, you
did not store the number successfully.
Start again from Step 1.
8. Write down the stored name and num-
ber on the memory index sticker pro-
vided.
Notes:
• If the low battery warning tone
sounds, recharge or replace the bat-
tery within two minutes, or the num-
bers stored in memory will be lost.
• If you receive a call while you are
storing a number in memory, press
TALK to answer the call. After the
call, begin at Step 1 to store a num-
ber.
• To change a number stored in mem-
ory, simply store a new number in that
memory location.
Entering a Pause in a Memory
Number
In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, if you do,
you should also store a pause after the ac-
cess code to allow the outside line time to
connect. After entering the access code,
press
REDIAL
to enter a 2-second pause.
Dialing a Stored Number
Press
TALK
. When you hear the dial tone,
press
MEM
then the memory location number
(
1–0
). The memory location number appears
and the phone dials the number.
To pre-dial a stored number, press
MEM
then
VOL/CID
8
88
8
or
9
99
9
to find the desired number,
then press
REDIAL/CALL BACK
.
Reviewing Stored Numbers
Press
MEM
. Enter the desired memory loca-
tion number (
1
,
2
,
3
, and so on), or press
VOL/CID
8
88
8
or
9
99
9
to scroll through the mem-
ory locations.
Deleting a Stored Number
1. Make sure the CHARGE/IN USE/MES-
SAGE indicator is not lit.
2. Press
MEM
then enter the memory loca-
tion number of the number to be
deleted, press
VOL/CID
8
88
8
or
9
99
9
to
select the memory location.
3. Press
FLASH/DELETE
.
;H7I;ý C;CE5
;H7I;ý C;CE5;H7I;ý C;CE5
;H7I;ý C;CE5
appears.
4. Press
FLASH/DELETE
again to clear the
memory. Two long beeps sound to con-
firm the number is deleted.
Or, press any other button to cancel the
deletion. Three short beeps sound.