Filter
Top Products
9
Important: Be sure the battery pack is
properly connected before you try to
charge it. The CHARGE/INUSE indica-
tor lights when the handset is on the
base, even if the battery pack is not con-
nected.
Notes:
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work and
you might hear an error tone when
you press
TALK
. If this happens, re-
turn the handset to the base for
about 5 seconds. This resets the se-
curity access-protection code.
• If the handset’s battery pack is com-
pletely depleted, the security ac-
cess-protection code might be lost.
To reset the code, return the hand-
set to the base for about 5 seconds.
• Using a pencil eraser, clean the
charging contacts on the handset
and the base about once a month.
• About once a month, fully discharge
the battery pack by keeping the
handset off the base until
Low
Battery
flashes with the phone
off-hook. Otherwise, the battery
pack loses its ability to fully re-
charge.
• If the display is blank and the phone
does not work, recharge the battery
pack. (The battery power might be
too low to light the display.)
• If you are not going to use your
phone for an extended period of
time, disconnect the battery pack.
This increases the battery pack’s
usable life.
• The supplied battery pack should
last for about a year. When it loses
its ability to fully recharge, order a
replacement battery pack from your
local RadioShack store (see “Re-
placing the Battery Pack” on
Page 24).
SETTING THE DIALING
MODE
Set
PULSE/TONE
on the back of the
base for the type of service you have. If
you are not sure which type you have,
once the battery pack is fully charged,
perform this test.
1. Be sure
PULSE/TONE
is set to
TONE
.
43-1111.fm Page 9 Tuesday, June 29, 1999 3:41 PM