Filter
Top Products
8
2. Plug one end of the supplied long
modular cord into the
TEL LINE
jack
on the back of the base.
3. Route the adapter and modular
cords through the grooves on the
bottom of the base.
4. Align the base’s keyhole slots with
the mounting screws and slide the
base downward to secure it.
CONNECTING AND
CHARGING THE BATTERY
PACK
The ET-1111 comes with a recharge-
able Ni-Cd battery pack in the handset
but not connected. Before using your
phone, you must connect the battery
pack, then charge it for about 24 hours.
1. Press down and slide off the battery
pack compartment cover as shown.
2. Lift the battery pack out of the com-
partment.
3. Plug the battery pack’s connector in-
to the socket in the compartment
(the connector fits only one way).
4. Replace the cover.
To charge the battery pack, place the
handset either faceup or facedown on
the base. The CHARGE/IN USE indica-
tor on the base lights and
Total:00
appears on the handset display.
Recharge the battery pack when the
handset beeps every 3 seconds and
Low Battery flashes on the display
during a call. You cannot make another
call until you recharge the battery pack.
43-1111.fm Page 8 Tuesday, June 29, 1999 3:38 PM