Filter
Top Products
7
3. Route the adapter’s cord through
the strain relief slot on the bracket.
4. Plug the adapter into a standard AC
outlet.
5. Lift the base’s antenna to a vertical
position.
On a Wall Plate or Wall
1. Plug one end of the supplied short
modular cord into the
TEL LINE
jack
on the back of the base as in “On a
Desk Top,” Step 1, on Page 6.
2. Insert the supplied AC adapter’s
barrel plug into the
DC IN 9V
jack as
in “On a Desk Top,” Step 3.
3. Route the adapter and modular
cords through the grooves on the
bracket.
4. Plug the modular cord’s other end
into the wall plate jack, then align
the bracket’s keyhole slots with the
wall plate studs and slide the base
downward to secure it.
5. Plug the adapter into a standard AC
outlet.
6. Press and lift out the handset hold-
er. Rotate it 180°, then snap it back
into place so it holds the handset.
7. Lift the base’s antenna to a vertical
position.
Note:
To mount the ET-1109 directly on
a wall, you need two screws (not sup-
plied) with heads that fit into the keyhole
slots on the bottom of the base.
Strain
Relief Slot
43-1109.fm Page 7 Friday, June 18, 1999 10:26 AM