Filter
Top Products
13
OPERATION
MAKING AND RECEIVING
CALLS
To make a call, lift the handset and
press
TALK
(the CHARGE/IN USE indi-
cator on the base lights), then dial the
number. The number displays on the
handset as you dial, then (after a few
seconds) the call’s elapsed time dis-
plays.
You can also dial the number before you
press
TALK
.
If you make a mistake, press
DELETE
until the incorrect entry is erased, then
enter the correct number. To delete the
entire number, hold down
DELETE
for at
least 2 seconds.
To answer a call, lift the handset from
the base and press
TALK
. If auto talk is
on, just lift the handset from the base. If
the handset is away from the base,
press any key.
To end a call, place the handset on the
base or press
TALK
.
SELECTING THE
CHANNEL
The ET-1109 has 30 channels (frequen-
cy pairs used between the base and
handset). If the call seems to disconnect
for no reason during a call, press
CH
on
the handset to select a different channel.
The display shows
Scanning as your
phone searches for a clear channel.
ADJUSTING THE
HANDSET VOLUME
To adjust the volume of the sound you
hear through the handset during a call,
press or on the handset until you
obtain the desired volume level.
Vol-
ume
Maximum, Volume High, Vol-
ume
Medium, or Volume Low
displays on the handset.
Once you set the volume level, the set-
ting is maintained even after you hang
up the phone.
TALK
MEM
FLASH
TONE
43-1109.fm Page 13 Friday, June 18, 1999 10:26 AM