Filter
Top Products
16
Each stored number can be up to 16 dig-
its long.
Storing a Number in Memory
Notes:
• If
T/P is set to P and you want to use
tone dialing for a memory number,
you must store a as the first entry
of the number you want to tone dial.
• Do not store a number with both
pulse and tone entries in the same
memory location. This could result
in a wrong number being dialed.
• Each pause and tone entry ( )
uses one digit of memory.
• To keep your accounts secure, we
recommend you do not store your
personal access code for services
such as bank-by-phone in a memory
location.
• An error tone sounds and the phone
exits the programming mode if you
wait more than 30 seconds between
each keypress or enter more than
16 digits. You must start over at Step
1.
1. Press
MEM. MEMORY STORE
appears.
2. Enter the number you want to store.
The number appears on the display.
If you enter an incorrect digit, start
from Step 1, then re-enter the cor-
rect digit.
3. Press
MEM. ENTER 01-20 ap-
pears.
4. Enter a two-digit memory location
number between 05 and 20 (01–04
are reserved for your VIP Call List).
The ET-1105 beeps twice, and the
display becomes blank.
5. To keep a record of each stored
number, use a flat-blade screwdriver
to lift the plastic cover from the tele-
phone number index card. Write the
name on the index card.
Note:
If you receive a call while you are
storing information in memory, press
TALK to answer the call. After the call,
begin again at Step 1.
To replace a stored number, store a new
one in its place.
Using the VIP Call List
Your phone lets you save 4 phone num-
bers in the memory location numbers
01–04 as its VIP Call List. Whenever
someone calls from one of those 4 num-
bers, if you subscribe to Caller ID, the
system sounds distinctive rings after the
first ring to alert you. displays when
you recall the phone numbers (see “Re-
calling Numbers Stored in Memory” on
Page 17).
MEM
VIP
43-1105.fm Page 16 Monday, August 30, 1999 1:57 PM