Radio Shack and Speakerphone Cordless Telephone User Manual


 
17
Operation
press
SPEAKER
. The call is released from
hold and transferred to the handset and the
display changes to
>WdZi[j
>WdZi[j>WdZi[j
>WdZi[j
_d
_d_d
_d
Ki[
Ki[Ki[
Ki[
. To bring
the base back into the conversation for a
three-way conference, press
SPEAKER
again.
OUT OF RANGE
If you have the handset out of the base's
range while a call is in progress, noise in-
creases. Return to the base’s range within
30 seconds, then you can resume your
phone conversation.
If you keep the handset out of the base’s
range for 30 seconds or more, the call is dis-
connected. However if you are in 3-way con-
ference call, the speakerphone call remains
connected.
USING A HEADSET
You can talk with handsfree convenience us-
ing an optional headset that has a
3
/
32
-inch
(2.5-mm) plug. Your local RadioShack store
has a variety of suitable headsets to chose
from.
To connect the headset, open the rubber
cover on the side of the handset, then insert
the headset's plug into the jack.
Notes:
Connecting a headset disconnects the
handset's earpiece and microphone.
VOL/CID
8
88
8
or
9
99
9
on the handset also
controls the connected headset's vol-
ume.
If you place the handset on the base to
recharge it while the headset is con-
nected, be sure the handset seats prop-
erly.
With a headset connected, you can make or
answer calls as usual using the keys on the
handset. You can also make or answer calls
by pressing the
SPEAKER
button located on
the base.
You can use a handset holder (available
from your local RadioShack store) to hang
the handset on your belt for greater conve-
nience.
When you finish using the headset, discon-
nect it from the handset and close the rubber
cover to protect the jack.
MEMORY DIALING
You can store up to 20 numbers in the hand-
set's memory and 10 in the base's memory,
then dial a stored number by pressing a
memory location number. You can also store
a name with each number in the handset's
memory.
Each number you store can be up to 20 dig-
its long, and each name can be up to 13
characters.
You cannot dial a number stored in one
memory location (the base or the handset)
using the keypad on the other.
Storing a Name and Number in the
Handset’s Memory
When you are storing a number in memory,
the phone beeps and exits the storing pro-
cess if you wait more than 20 seconds be-
tween each keypress.
Note:
If you receive a call during memory en-
try, the phone exits the storing process.