Filter
Top Products
13
Operation
Notes:
• Connecting a headset disconnects the
handset’s earpiece and microphone.
•
8
88
8
or
9
99
9
on the handset also controls
the headset’s volume.
• If you place the handset on the base to
recharge it while the headset is
connected, be sure the handset seats
properly.
• With a headset connected, you can
make or answer calls as usual using the
keys on the handset.
• You can use a handset holder (available
from your local RadioShack store) to
hang the handset on your belt for
greater convenience when using a
headset.
• When you finish using the headset,
disconnect it from the handset and close
the rubber cover to protect the jack.
MEMORY DIALING
You can store up to 10 phone numbers and
names in memory, then dial a stored number
by entering its memory location number.
Each number can be up to 20 digits, and
each name can be up to 14 characters.
Storing a Number and Name in
Memory
1. Lift the handset.
2. Hold down
MEM
until
C[ceho
C[cehoC[ceho
C[ceho
Ijeh[
Ijeh[Ijeh[
Ijeh[
and a
list of memory location numbers
appears.
3. Select an empty memory location (or the
one you want to replace) by entering the
location number (
1
–
0
) or using
8
88
8
or
9
99
9
to scroll through the list.
4. Press
SELECT
.
Ijeh[
Ijeh[Ijeh[
Ijeh[
DWc[
DWc[DWc[
DWc[
appears. If
you do not want to enter a name, skip to
Step 6.
5. To enter a name, use the number keys.
Refer to the letters on the number keys
to select the desired letter. Press the key
once for the first letter in the upper case,
press twice for second letter in the upper
case, and so on. To enter the lower case
letter, press four times (or five times) to
display the first letter in lower case, five
or six times for second letter, and so on.
For example, to enter John: press
5
once; upper case
@
@@
@
appears. Then press
6
six times; lower case
e
ee
e
appears. Press
4
five times; lower case
^
^^
^
appears.
Finally, press
6
five times; lower case
d
dd
d
appears.
To enter two letters from the same key in
a row, press
#
/
7
77
7
to move the cursor to
the next position. For example to enter
AB, press 2;
7
77
7
appears. Then press
#
/
7
77
7
, the cursor moves to next position,
then press 2 twice so
8
88
8
appears.
To enter a space, press
#
/
7
77
7
twice
without entering any character.
To enter a number, repeatedly press the
corresponding number key until the
number appears.
To enter a special character, press
0
.
Each time you press
0
, the following
characters appear in this order:
∗
#
¶
¶¶
¶
&
â
ââ
âýá
ýáýá
ýá
(space)
&
&&
&
If you make a mistake, use
∗
/TONE/
6
66
6
or
#
/
7
77
7
to move the cursor over the
error, then enter the correct character, or
press
DELETE
to delete a character. To
delete all characters, hold down
DELETE
for at least 1 second.
6. Press
SELECT
.
Ijeh[
Ijeh[Ijeh[
Ijeh[
DkcX[h
DkcX[hDkcX[h
DkcX[h
appears.