Filter
Top Products
29Care
If the base loses power while the handset is off of it, the security access-protection
code might change. Restore power to the base, then place the handset back on the
base and leave it there for a few seconds.
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
ˆ
Care
To enjoy your RadioShack 2-Line 900 MHz Cordless Answering System for a long
time:
• Keep the telephone dry. If it gets wet, wipe it dry immediately.
• Use and store the telephone only in normal temperature environments.
• Handle the telephone gently and carefully. Do not drop it.
• Keep the telephone away from dust and dirt.
• Wipe the telephone with a damp cloth occasionally to keep it looking new.
Handset does not ring or
receive a page.
• Lift the base’s antenna to a vertical position.
• Move the handset closer to the base.
• Move the handset and base away from other electrical
devices.
• Recharge the battery pack.
The TAD does not answer
calls.
• Make sure the TAD is turned on.
• Make sure the AC adapter is properly connected.
• Check all phone line connections.
The TAD does not record
callers’ messages.
•
REC TIME
is set to
ANN
(announcement only). Set it to
1
or
4
.
• Delete message if memory is full.
E E
flashes. • Microprocessor failure. Disconnect the AC adapter, wait 15
seconds, then plug in the adapter again.
Problem Suggestion