Filter
Top Products
Operation
7
1. Lift the handset and listen for a dial tone.
2. Press any number other than
0
.
±
If the dial tone stops, you have touch-tone service. If the dial
tone continues, you have pulse service.
To set the dialing mode, hold down
FLASH
until the phone
beeps and TALK/BATT flashes, then press
#
to set the phone
to pulse mode or
TONE/∗
to set the phone to tone mode.
12'4#6+10
/#-+0)"#0&"4'%'+8+0)"%#..5
To make a call, lift the handset and press
TALK
. To answer a
call, simply lift the handset. Or, if the handset is not in place
on the base, press
TALK
or any number key,
#
, or
∗
. The
TALK/BATT indicator on the handset and the CHARGE/IN
USE indicator on the base light.
To end a call, place the handset on the base or press
END
.
The TALK/BATT and CHARGE/IN USE indicators turn off.
±
5'.'%6+0)"6*'"%*#00'.
The phone scans 20 channels (frequency pairs used be-
tween the base and the handset) and automatically selects
a clear channel each time you make or receive a call.
If you hear other conversations or you experience difficulty
hearing the conversation, press
CHANNEL
to select a
different channel. TALK/BATT flashes and the handset
beeps, followed by a brief pause as your phone searches
for a clear channel.
±
#&,756+0)"6*'"*#0&5'6N5"81.7/'
To adjust the volume of the sound you hear through the
handset during a call, repeatedly press
VOL/RING
.
75+0)"4'&+#.
You can quickly dial the last number you dialed. Lift the
handset and press
PAUSE/REDIAL
when you hear a dial
tone.
±
75+0)"(.#5*
FLASH
performs the electronic equivalent of a switchhook
operation for special services, such as Call Waiting. For
example, if you have Call Waiting, press
FLASH
to answer
an incoming call without disconnecting the current call.
Press
FLASH
again to return to the first call.
±ý
±
"016'"
±
"
Setting the Dialing Mode
• If your phone system requires
that you dial an access code (9,
for example) before you dial an
outside number, do not dial the
access code.
• The phone exits setting mode if
a call or page is received, or if
you press
END
.
• If the battery power becomes
too low, the dialing mode might
reset to tone. If you are on a
pulse line and cannot make a
call, try setting the dialing mode
to pulse.
Making and Receiving Calls
If the handset is too far from the
base while the phone is in use,
pressing
END
might not disconnect
the phone. Hang up the handset on
the base.
Selecting the Channel
If the handset is too far from the
base, an error tone sounds and the
channel might not change. Move
closer to the base.
Using Redial
• The redial memory holds up to
24 digits, so you can redial long-
distance as well as local
numbers.
• The redial memory also holds
pause entries (see “Entering a
Pause” on Page 9).
• The redial memory does not
store a flash entry or any digits
you press before
FLASH
(see
“Using Flash” on Page 7).
Using Flash
If you do not have any special
phone services, pressing
FLASH
might disconnect the current call.
43-3533.fm Page 7 Friday, June 28, 2002 2:36 PM