Filter
Top Products
Installation
8
O
N
A
D
ESK
T
OP
1. Plug one end of
the supplied long
modular cord into
the
TEL
LINE
jack
on the bottom of
the base.
2. Insert the supplied
AC adapter’s
barrel plug into the
DC IN 9V
jack on
the bottom of the
base and route the
adapter’s cord
through the strain
relief slot on the base.
""
""
3. Plug the other end of the modular cord
into a modular phone line jack.
4. Plug the adapter into a standard AC
outlet.
O
N
A
W
ALL
P
LATE
OR
W
ALL
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the base.
Drill two holes 3
15
/
16
inches apart. Thread a
screw into each hole, letting the heads
extend about
1
/
8
inch.
1. Plug one end of the supplied modular
cord (short for a wall plate, long for
direct wall mounting) into the
TEL LINE
jack on the base’s back.
2. Plug the supplied AC adapter's barrel
plug into the
DC IN 9V
jack.
3. Route the adapter and modular cords
through the base’s grooves.
TEL
LINE
DC IN 9V
" CAUTION "
You must use
a Class 2
power source
that supplies
9V DC and delivers at
least 350 mA. Its center
tip must be set to
positive and its plug
must fit the phone’s DC
IN 9V jack. The supplied
adapter meets these
specifications. Using an
adapter that does not
meet these
specifications could
damage the phone or
the adapter.
!
43-3549.fm Page 8 Tuesday, May 25, 2004 2:15 PM