Filter
Top Products
9
Preparation
Cautions:
You must use a Class 2 power source that supplies
15V DC and delivers at least 300 mA. Its center tip
must be set to positive and its plug must fit the
phone's 15V 300 mA jack. Using an adapter that does not
meet these specifications could damage the phone or the
adapter.
• Always connect the AC adapter to the phone before you con-
nect it to AC power. When you finish, disconnect the adapter
from AC power before you disconnect it from the phone.
1. If you have a RJ14C modular telephone line jack for 2 line
usage, plug one end of the supplied 4-pin modular cord into
TEL LINE 1/2
. Then plug the other end into the RJ14C mod-
ular phone line jack.
If you have two RJ11C modular telephone line jacks for
using 2 lines, plug one end of the supplied 4–pin modular
cord into
TEL LINE 1/2
, and one end of the supplied 2–pin
modular cord into
TEL LINE 2
. Then plug the modular cords’
other ends into the RJ11C modular phone line jacks.
2. Lift the base’s antenna to a vertical position.
CONNECTING AND CHARGING THE
BATTERY PACK
The phone comes with two rechargeable nickel-cadmium bat-
tery packs. You must connect the battery pack and charge it for
at least 12 hours for the first time before you use the phone.
!
43-1701.fm Page 9 Wednesday, September 20, 2000 8:48 AM