Filter
Top Products
13
Preparation
CONNECTING AND ADJUSTING THE
HEADSET
1. Insert the tabs on the headset holder
into the slots on the back of the base
and snap the holder into place.
2. Insert the headset’s plug into the jack
on the side of the keypad.
3. Place the headset on your head
with the earpiece over either ear.
4. Adjust the headset band until it
rests with almost no pressure
on your ear and the top of your
head.
5. If the headset is loose, press in slightly to tighten it. If it is
tight, gently pull the headset band out to loosen it.
6. Hold the headset in place and adjust the microphone boom
until it is about even with (but not in front of) your mouth.
Experiment until you find the most comfortable position.
Caution:
The microphone boom swivels on the headset. Do not
bend the microphone boom while you adjust it.
Note:
When you are not using the headset, place it on the
headset hanger. Otherwise (if you set it on a flat surface, for ex-
ample), you might have to repeat these adjustments.
43-1701.fm Page 13 Wednesday, September 20, 2000 8:48 AM