Filter
Top Products
10
Installation
Note:
To mount the phone directly on a wall,
you need two screws of at least 1
3
/
8
inch long
(not supplied) with heads that fit into the key-
hole slots on the bottom of the base.
Follow the steps under “On a Wall Plate or
Wall” on Page 9, then apply these additional
instructions for placement on a wall.
1. Drill two holes 3
15
/
16
inches (100 mm) apart.
Then thread a screw into
each hole, letting the
heads extend about
1
/
8
inch (3 mm) from the wall.
2. Plug one end of the sup-
plied long modular cord
into the
TEL LINE
jack on the back of the
base and route the adapter cable and
modular cords through the grooves on
the base.
3. Align the base’s keyhole slots with the
mounting screws and slide the base
downward to secure it.
CONNECTING, CHARGING,
AND REPLACING THE
BATTERY PACK
The telephone comes with a rechargeable
nickel-cadmium battery pack installed in the
handset, but not connected. Before using
your phone, you must connect the battery
pack, then charge it for about 24 hours.
Follow these steps to connect the battery
pack.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the compart-
ment.
3. Plug the battery pack’s connector into
the socket in the compartment (the con-
nector fits only one way), replace the
battery pack, then replace the cover.
To charge the battery pack, place the hand-
set either up or down on the base. The
CHARGE/IN USE indicator on the base
lights and
JejWb0&&
JejWb0&&JejWb0&&
JejWb0&&
appears on the handset.
Recharge the battery pack when
Bem
BemBem
Bem
8Wjj[ho
8Wjj[ho8Wjj[ho
8Wjj[ho
flashes on the handset.
Important:
Be sure the battery pack is prop-
erly connected before you try to charge it.
The CHARGE/IN USE indicator lights when
the handset is on the base, even if the bat-
tery pack is not properly connected.
Notes:
• When you first use the phone after
charging or recharging the battery pack,
the phone might not work and the phone
might beep several times when you
press
TALK
. Return the handset to the
base for about 5 seconds to reset the
security access-protection code.
• If the handset or the base loses power,
the security access-protection code
might be lost. To reset the code, return
the handset to the base for about 5 sec-
onds.
3
15
/
16
"
1
/
8
"