Filter
Top Products
18
5.1.2 Service domain / Second realm / Third realm
5.1.2.1 First / Second / Third realm
5.1.2.1.1 Activation
5.1.2.1.2 User name
5.1.2.1.3 Display name
5.1.2.1.4 Register name
5.1.2.1.5 Register password
5.1.2.1.6 Proxy server
5.1.2.1.7 Domain server
5.1.2.1.8 Outbound proxy
5.1.3 Codec
5.1.3.1 Codec type
5.1.3.1.1 G.711 uLaw
5.1.3.1.2 G.711 aLaw
5.1.3.1.3 G.723
5.1.3.1.4 G.729
5.1.3.1.5 G.726-16
5.1.3.1.6 G.726-24
5.1.3.1.7 G.726-32
5.1.3.1.8 G.726-40
5.1.3.2 VAD: Voice Active Detection Enable/Disable
5.1.4 RTP setting
5.1.4.1 Outband DTMF
5.1.4.2 Duplicate RTP
5.1.4.3 No duplicate
5.1.4.4 One duplicate
5.1.4.5 Two duplicate
5.1.5 RPort Setting: RPort Enabled/Disabled
5.1.6 Hold by RFC
5.1.7 Status: Show the SIP Proxy registers status.You can use
UP/Down key to check each Realm’s status
5.1.7.1 First Realm / Second Realm / Third Realm
6 NAT
Transversal
6.1.1 STUN setting
6.1.1.1 STUN: STUN Enabled/Disabled
6.1.1.2 STUN server
7 Administrator
7.1.1 Auto Config
7.1.1.1 Config Mode: You can select
Disable/TFTP/FTP/HTTP/IP-PBX to do the auto config
function. This function must work with the Auto Config
Server.
7.1.1.2 TFTP server: Setting the TFTP server IP address.
7.1.1.3 FTP server: Setting the FTP server IP address.
7.1.1.4 FTP Login Name: Setting the login name to the FTP
server.
7.1.1.5 FTP Password: Setting the Password to the FTP
server.
7.1.2 Default setting: You can restore to the default setting
7.1.3 System Authentication: To do the SIP setting from Keypad,
need to input the password first. Default is “null” (not
password).
7.1.4 Version: This will show the system’s firmware version.
7.1.5 Restart: You can use this function to restart your IP Phone