Philips DECT511 Telephone User Manual


 
Troubleshooting
59
http://www.philips.com/faqs/dect
Troubleshooting
The icon does not
scroll when the handset is
placed on the base
PROBLEMS
No dialling tone
- Crackling on the line
The handset displays ‘not
available’
- when attempting to add
another handset to the base
station
- when using a handset
Noise interference on your
radio or television
Caller Line Identification (CLI)
service does not work
No ring tone
The icon does not appear
The icon is blinking
- Bad battery contact
- Dirty contact
- Battery is full
CAUSES
- No power
- Batteries are empty
- You are too far from the base station
- Wrong cable
- Line adaptor not plugged to the
line cord
- The ring tone is deactivated
- The Do not Disturb mode is ON
- No mains power
- The handset is too far from the
base station
- Handset not registered to the
base station
- You are too far from the base
station
- The base station is too close to
electrical appliances, reinforced
concrete walls or metal door-
frames
- The procedure to add a handset
has failed, try again
- Maximum number of handsets (6)
has been reached
- Base station is already busy with
another handset (ie : phonebook)
The DECT 511/515 base station or
mains power pack are too close to
electrical appliances
- The service is not activated
- Move the handset slightly
- Clean the contact with a cloth
moistened with alcohol
- No need to charge
SOLUTIONS
- Check the connections. Reset
the phone : unplug and plug back
in the mains
- Charge the batteries at least 24
hours
- Move closer to the base station
- Always use the cable provided
- Plug the line adaptor to the line
cord
- Increase the volume (page 50)
- Deactivate it (page 48)
- Check connections
- Move closer to the base station
- Register the handset to the base
(page 28)
- Move closer to the base station
- Move the base station to find a
better place (the higher the
better)
- Disconnect and connect the
base station power supply. Follow
the procedure to register a
handset (page 28)
- Un-register a handset
- Wait until it is available
Move the power pack or base
station as far as possible
- Check your subscription with
your network operator
Telephone troubleshooting
www.philips.com/support
DECT511_GBIE_part2_indice2_internet.qxd 26/10/2004 14:42 Page 25