Filter
Top Products
Appendix 57
20.6 Noise
Electrical pulse noise is present at one
time or another. This is most intense
during electrical storms. Certain kinds of
electrical equipment, such as light
dimmers, fluorescent bulbs, motors, fans,
etc., also generate pulse noise. Because
radio frequencies are susceptible to this,
you may on occasion hear pulse noise
through the receiver. This is usually only
a minor annoyance and should not be
interpreted as a defect of the unit.
20.7 FCC RF Radiation Exposure
Statement
This equipment complies with FCC RF
radiation exposure limits set forth for an
uncontrolled environment. This
equipment should be installed and
operated with a minimum distance of 20
centimeters between the radiator and
your body. This transmitter must not be
co-located or operating in conjunction
with any other antenna or transmitter.
For hand held operation, this phone has
been tested and meets the FCC RF
exposure guidelines. For Body-worn
operation, use only with the belt clip. Use
of other accessories may not ensure
compliance with FCC RF exposure
guidelines.
20.8 Hearing Aid Compatibility
(HAC)
This telephone system meets FCC and
Industry Canada standards for Hearing
Aid Compatibility.
20.9 Privacy
Privacy of communications may not be
ensured when using this telephone.
20.10 Additional Information
I.C. Notice
20.11 Terminal Equipment
Note
This equipment meets the applicable
Industry Canada Terminal Equipment
Technical Specifications.
This is confirmed by the registration
number. The abbreviation, IC, before the
registration number signifies that
registration was performed based on a
Declaration of Conformity indicating that
Industry Canada technical specifications
were met. It does not imply that Industry
Canada approved the equipment.
Note
The Ringer Equivalence Number (REN)
for this terminal equipment is marked on
the equipment itself. The REN assigned to
each terminal equipment provides an
indication of the maximum number of
terminals allowed to be connected to a
telephone interface. The termination on
an interface may consist of any
combination of devices subject only to
the requirement that the sum of the
Ringer Equivalence Numbers of all the
devices does not exceed five.