Philips CD170 Telephone User Manual


  Open as PDF
of 40
 
12
3 Connect each end of the line cord to:
the telephone socket at the bottom of •
the base station;
the telephone socket on the wall.•
Install the handset
Caution
Risk of explosion! Keep batteries away from •
heat,sunshineorre.Neverdiscardbatteries
inre.
Use only the supplied batteries.
•
Risk of decreased battery life! Never mix •
different brands or types of batteries.
Note
Chargethebatteriesfor16hoursbeforerst •
use.
Warning
Check the battery polarity when inserting in •
the battery compartment. Incorrect polarity
may damage the product.
3 Get started
Caution
Ensure you have read the safety instructions in •
the “Important” section before you connect
and install your handset.
Connect the base station and
charger
Warning
Risk of product damage! Ensure that the •
power supply voltage corresponds to the
voltage printed on the back or the underside
of the phone.
Use only the supplied power adapter to charge
•
the batteries.
Note
If you subscribe to the digital subscriber line •
(DSL) high speed internet service through
your telephone line, ensure you install a DSL
lterbetweenthetelephonelinecordand
thepowersocket..Thelterpreventsnoise
and caller ID problems caused by the DSL
interference. For more information on the DSL
lters,contactyourDSLserviceprovider.
The type plate is located on the bottom of the
•
base station.
1 Connect each end of the power adapter
to:
the DC input jack at the bottom of the •
base station;
the power socket on the wall.•
2 Connect each end of the power adapter
to (for multi handset packs):
the DC input jack at the bottom of the •
extra handset charger.
the power socket on the wall.•
EN
IFU_CD170-175_05_EN.indd 12 2009-12-17 17:30:36
 previous next