Philips CD170 Cordless Telephone User Manual


  Open as PDF
of 40
 
34
Activate/deactivate the remote access
You can allow or block remote access to the
answering machine.
1 Press MENU.
2 Select [ANSW MACHINE] >
[SETTINGS] > [REMOTE ACC.], then
press OKtoconrm.
3 Select a new setting, then press OK to
conrm.
The setting is saved. »
Access the answering machine
remotely
1 Make a call to your home number with a
touch tone phone.
2 Enter # when you hear the
announcement.
3 Enter your PIN code.
You now have access to your »
answering machine, and you can now
listen to the new messages.
Note
You have 2 chances to enter the correct PIN •
code before your phone hangs up.
4 Press a key to carry out a function. See
the Remote access commands table
below for a list of available functions.
Note
When there is no message, the phone hangs •
up automatically if no key is pressed for 8
seconds.
Note
Ensure that the answering machine is switched •
on before this feature can be applied.
Tip
When you access the answering machine •
remotely, you are recommended to set the
ring delay to [ECONOMY] mode. This is a
cost effective way to manage your messages.
When there are new messages, the answering
machine picks up the call after 3 rings; When
there is no messages, it picks up the call after
5 rings.
Remote access
You can operate your answering machine when
you are away from home. Simply make a call to
your phone with a touch tone phone and enter
your 4-digit PIN code.
Note
The remote access PIN code is the same as •
your system PIN. The preset PIN is 0000.
Change the PIN code
1 Press MENU.
2 Select [ANSW MACHINE] >
[SETTINGS] > [REMOTE ACC.] >
[CHANGE PIN], then press OK to
conrm.
3 Enter the old PIN, then press OK to
conrm.
4 Enter the new PIN code, then press OK
toconrm.
5 Enter the new PIN code again, then press
OKtoconrm.
The setting is saved. »
EN
IFU_CD170-175_05_EN.indd 34 2009-12-17 17:30:43
 previous next