Philips CD170 Cordless Telephone User Manual


 
16
1 Press R during a call.
Therstcallisputonhold. »
2 Dial the second number.
The number displayed on the screen is »
dialed out.
Answer a second call
Note
This service is network dependent.
When there is a periodical beep to notify you
of an incoming call, you can answer the call in
these ways:
1 Press R and to answer the call.
Therstcallisputonhold,andyou »
are now connected to the second call.
2 Press R and to end the current call
and answer the second call.
Toggle between two calls
1
Press R and .
The current call is put on hold, and you »
are now connected to the other call.
Make a conference call with
the external callers
Note
This service is network dependent. Check with
the service provider for additional charges.
When you are connected to two calls, press R,
then
.
The two calls are combined and a »
conference call is established.
Answer a call
When the phone rings, press to answer
the call.
Note
The caller ID service is available if you have
registered to the caller ID service with your
service provider.
Tip
When there is a missed call, the handset
displaysanoticationmessage.
Turn off the ringer for all incoming
calls
There are two ways to turn off the ringer:
1 Press and hold in standby mode.
»
displays on the screen.
2 When the phone rings, press BACK.
Adjust the earpiece volume
Press or to adjust the volume during a call.
The earpiece volume is adjusted and the phone
is back to the call screen.
Mute the microphone
1
Press during a call.
The handset displays » [MUTE ON].
The caller cannot hear you, but you »
can still hear his voice.
2 Press again to unmute the microphone.
You can now communicate with the »
caller.
Make a second call
Note
This service is network dependent.
EN
IFU_CD170-175_05_EN.indd 16 2009-12-17 17:30:39