Filter
Top Products
Setting up the VoIP SIP phone 26
SmartLink 4050 Series Getting Started Guide 2 • Installing the SmartLink SIP Phone
Note You can stop the setup process at any time by pressing MENU + OK to save
any changes and exit, or by pressing MENU + CANCEL to quit without
saving. The phone will automatically time-out and exit the menu screen if
there are no inputs from the user.
Use left and right arrows on the control pad to select ENABLE or DISABLE.
The left arrow key can also be used as a backspace key to delete characters.
Display Name
1. Press
2. Use the numeric keypad to enter the display name
Note To type text characters, press the appropriate key on the numeric keypad (see
figure 1 on page 17). For example, to type a “z” press the 9 key until the low-
ercase z appears—the displayed sequence would be:
9 W X Y Z w x y z.
Display Name
Some Internet Service Provider (mostly ADSL) uses PPPoE which requires that the user enter an ID and a
password to access the Internet. In this case, enable ADSL DIALUP and enter the PPPoE ID and
PPPoE password.
ENABLE ADSL dialup
1. Press
2. Use to select ENABLE
3. Press
4. Enter the ADSL ID
5. Press
6. Enter the ADSL password