Filter
Top Products
14
Parrot MK6100
Double sided tape
Doppelseitiges Klebeband
Klebeband
Car Stereo Without iSo ConneCtorS
• To simplify the wiring procedure, you will need to purchase an ISO adapter cable.
• Refer to the range of ISO adapters on our website: www.parrot.com
inStalling the kit’S poWer Cable
• Refer to your car stereo’s wiring diagram.
• The red wire of the kit’s cable must correspond to the constant +12V supply,
the orange wire to the ignition +12V and the black wire to ground.
• Check that the orange wire is not connected to the constant +12V supply, as
you could run down the vehicle’s battery, preventing your hands-free kit from
operating correctly.
• On some vehicles, the red and orange power supply wires may need to be
reversed. This can easily be done by reversing the two fuse holders on the Parrot
MK6100 installation cable.
Note: on some vehicles, there is no ignition +12V on the vehicle’s connectors.
You must therefore connect the orange power supply wire to the fuse box or
another ignition power source.
CheCking the Wiring
• When you switch off your vehicle’s ignition, you should see «Goodbye» on the
Parrot MK6100 screen.
Otherwise, the ignition +12V and the constant +12V supply have been reversed. In
this case, reverse the two fuse holders on the kit’s power supply lead.
Choose the place for the control screen inside your vehicle. We would advise you to
fit it in the centre of the dashboard or near you. You can place the wireless controls
either on the dashboard or the steering wheel. Ensure that you place them within
easy reach.
IMPORTANT: if you place them on the steering wheel, make sure that they are securely
attached, so that they do not move when you are driving. Do not install the controls
on the outside of the steering wheel, so that they do not get in the way when driving.
inStalling the parrot mk6100 SCreen
There are two different ways to install the
Parrot MK6100 screen.
The first way lets you place the screen against
the dashboard.
• Stick the double-sided tape to the flat side
of the connector of the screen’s cable and
then fix against the dashboard.
• Then insert the screen into its connector.