Filter
Top Products
DBS
Release Notes
Panasonic@
CPC-EX, Version 1 .O (Preliminary)
June
lo,1996
_.
.
Independent Node Attendant Assignment
A central network operator can be assigned for Dial 0 access from any node. Each node can
independantly designate a network attendant. For example, Nodes
1,2
&
3 can send Dial 0 calls to
the attendant on Node 1, while Node 4 sends Dial 0 calls to its local attendant.
Settings Modified for Networking
The following programming addresses have been modified to add parameters necessary for
Tl
networking. (See
the
TI
Networking Reference Manual
for
complete instructions)
Extension Number Digits
Description
The CPC-EX card allows a 4-digit extension numbering plan to be used on
networked DBS systems. The first digit of the extension determines on which
DBS the extension is located
-
for example, extension 1321 will be on DBS 1,
while extension 2547 will be on DBS 2. Each DBS routes calls based on the
leading digit of the dialed extension.
A DBS operating in a network environment must use the 4-digit extension
numbering plan. Stand-alone (non-networked) DBS systems, however, must
continue to use 2 or 3 digit extensions.
Programming
to specify the length of extension numbers...
FFI
2#
I##
12#
(O-2)#
+f
0=2-digit
numbering
1=3-digit
numbering
new-W
2=4-digit numbering
Note: An extra
“#”
must be entered to
confii the selection.
(or press
9”
to cancel)
Page 38
l
Tl
Networking
Technical Manuals Online! - http://www.tech-man.com