Filter
Top Products
Panasonic@
June
lo,1996
DBS
Release Notes
CPC-EX, Version 1 .O (Preliminary)
Notes
You can program the
*71
ring select comand into an FF key. Pressing the key
toggles between “Analog Port RING” and “Key Tel RING”. When the analog port
is set to ring, the FF key LED lights red. When the key telephone is set to ring, the
LED is off.
Phone Restrictions
l
The Analog Adapter will work on the large-display phone only (VB-44225).
l
A dial-pulse SLT will not function on the analog port.
l
Stutter Dial Tone (indicating Call-Forwarding mode, Do-Not-Disturb mode,
etc.) will not function on an SLT connected to the Analog Adapter.
l
An analog phone connected to the Analog Adapter cannot program or access
speed dials.
Incoming Calls
l
You cannot program both devices to ring simultaneously.
l
The “*71” code will not work if the other device is in use.
l
The “*71” code will not work if
FF3
(ExtPort)# 51# is set to “0”.
l
If set to “Analog port RING”, the large-display phone will work like an
SLT/OPX (no page announcements, no voice calls from other extensions, etc.).
l
If the phone is in CF/DND (Call-Forward or Do Not Disturb), the phone will
remain in CF/DND even if the ringing device is changed via the
*7
1 code.
l
The incoming ring pattern for the analog device is the same as for the digital
key telephone (determined by the Extension Ring Pattern in FF3 (ExtPort)#
39#
(0-9)#).
If this address is set to “0” (determined by CO), the analog device will
automatically default to “1 second ON, 3 seconds OFF.”
Ring Patterns Not Applicable to Analog Device.
The following ring pattern
addresses
will
not
affect the analog device:
Analog Transfer Ring Pattern
FFl
2#
l#
31#
(0-6)#
SLT DISA Ring Pattern
FFl
2#
l#
34#
(0 or
l)#
Inbound Ring Pattern
FF2
(Trunk)#
17#
(0-9)#
Flash Interaction.
Any disconnect signal sent to the analog port must be greater
than the SLT Flash Control; otherwise the disconnect signal will be interpreted as
a flash and the call will be placed on hold.
Programming Addresses That Affect the Analog Device.
The following
addresses will control the analog device, but will not affect the digital key
telephone:
AEC Disconnect Duration
FFl
2#
l#
35#
(O-15)#
SLT Flash Control
FFl
2#
l#
ll#
(0 or
l)#
44-Series New Phone Features
l
Page 21
Technical Manuals Online! - http://www.tech-man.com