Filter
Top Products
69
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
General
Problem
The unit does not work.
You cannot program items,
such as the dialing mode.
You cannot register the
handset at the base unit.
Cause & Remedy
•Check the settings (p. 8–10).
•Check whether the dialing mode setting is
correct (p. 15).
•Charge the battery fully (p. 9).
•Clean the charge contacts and charge again
(p. 10).
•Install the battery properly (p. 9).
•Unplug the AC adaptor of the base unit to
reset. Plug in, and try again.
•The handset has not been registered to the
base unit. Register the handset (p. 24, 63).
•Re-install the battery (p. 61) and charge it fully.
•Programming is not possible while the
handset is being used.
•Do not pause for over 60 seconds while
programming.
•Move closer to the base unit.
•
Ö, Ñ, Ü or á may have been pressed
when you picked up the handset. Press
(OFF)
and try again.
•If more than one other user is using the
handsets, you may not be able to program.
Try again later.
•Charge the battery fully (p. 9).
•The maximum of 3 handsets have already
been registered to the base unit.
•This base unit has the memory of the
handset currently registered to another base
unit. Erase the handset memory from the
base unit.
For KX-TG2382B base unit:
(1)
Press and hold
HANDSET LOCATOR/INTERCOM (ALL)
until the CHARGE indicator flashes.
(2) Press and hold
HANDSET LOCATOR/INTERCOM ((1) to (3))
of the handset number that you want to
erase until the CHARGE indicator flashes,
then rapid flashes, then goes out.