Filter
Top Products
18
Programmable Functions
You can program the following function items using the handset near
the base unit. The display shows the programming instructions. See the
corresponding pages for function details. Make sure the unit is not
being used and the handset is lifted off the base unit.
During programming:
*To select a desired function item, scroll through the items by pressing Ö or Ñ.
Then press
á to go to the next step.
•“--------------” indicates the beginning or end of the function menu
.
•You can exit the programming mode any time by pressing (OFF).
•If you do not press any buttons for 60 seconds, the unit will exit the programming
mode.
•If the handset has lost communication with the base unit, 3 beeps sound and “No
link to base Place on cradle and try again.” is displayed.
Press (HOLD/FUNCTION/CLEAR).
<Function menu>*
To store an item in the directory (p. 37).
To select the ringer volume (p. 20).
To select the ringer tone (p. 21).
Press á.
--------------
H
Save directory
Ringer volume
Ringer tone
Program
--------------
--------------
H
Set flash time
Save VM acces#
VM tone detect
Set line mode
Set dial mode
Line selection
Incoming call.
Auto talk
CallerID edit
LCD contrast
--------------
To select the flash time (p. 53).
To store a voice mail access number (p. 44).
To set the voice mail tone detection(p. 46).
To select the line mode (p. 17).
To select the dialing mode (p. 16).
To change the line selection (p. 54).
To set the incoming call tone (p. 55).
To set the Auto Talk feature (p. 19).
To set the Caller ID Number Auto Edit feature (p. 33).
To select the LCD contrast (p. 22).
<Function menu>*