Filter
Top Products
17
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Line Mode
If the line is connected to a low voltage system such as a PBX, set to “B”.
Your phone comes from the factory set to “A”.
Make sure the unit is not being used and the handset is lifted off the
base unit.
1
Press (HOLD/FUNCTION/CLEAR).
2
Scroll to “Program” by pressing Ö or Ñ.
3
Press á.
4
Scroll to “Set line mode” by pressing
Ö or Ñ.
5
Press á.
6
Press Ö (Line1) or Ñ (Line2) to select
the line.
•The line’s current setting will be displayed.
7
Select “B” or “A” by pressing Ö or Ñ.
8
Press á (Save key).
•A beep sounds.
•To program the other line, start again from step 4.
•To exit the programming mode, press (OFF).
•You can exit the programming mode any time by pressing (OFF)
.
Line mode
G
=Line1
F
=Line2
Line mode
Line1:B
Line mode
Line1:A
GF H
=Save
--------------
H
Save directory
Ringer volume
Ringer tone
H
Program
--------------
--------------
H
Set flash time
Save VM acces#
VM tone detect
H
Set line mode
Set dial mode
Line mode
Line1:B
GF H
=Save