Filter
Top Products
Useful Information
28
Registering a handset to the base unit
1 Handset:
{j/OK}
2 {r}: “Setup” s {j/OK}
3 {r}: “Register HS” s {j/OK}
4 Base unit:
Press and hold {x} for about 5 seconds. (No registration tone)
L If all registered handsets start ringing, press {x} again to stop, then repeat this step.
(KX-TGB212/KX-TGB213)
5 Handset:
Wait until “PIN:____” is displayed. s Enter the base unit PIN (default: “0000”). s
{j/OK}
L If you forget your PIN, contact an authorised service centre.
L The next step must be completed within 90 seconds.
6 Wait until a long beep is heard and then enter the desired handset number you want to
register.
L When the handset has been registered successfully, w stops flashing.
L If w is still flashing, start again from step 1.
Deregistering a handset
A handset can cancel its own registration to the base unit, or other handsets registered to the
same base unit. This allows the handset to end its wireless connection with the system.
1 {j/OK}y131 s Enter the base unit PIN (default: “0000”).
L All handsets registered to the base unit are displayed.
2 Enter the desired handset number you want to cancel. s {j/OK}
L A confirmation tone sounds.
3 {m}
Changing the base unit PIN (Personal Identification Number)
Important:
L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to
you. If you forget your PIN, contact an authorised service centre.
1 {j/OK}
2 {r}: “Setup” s {j/OK}
3 {r}: “Change PIN” s {j/OK}
4 Enter the current 4-digit base unit PIN (default: “0000”).
5 Enter the new 4-digit base unit PIN.
6 Enter the new 4-digit base unit PIN again. s {m}
TGB21xBX_UE(en).book Page 28 Friday, May 30, 2014 11:54 AM