Filter
Top Products
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
(middle soft key) #132
2 Enter the current 4-digit base unit PIN
(default: “0000”).
3 Enter the new 4-digit base unit PIN. a
a M N
Changing the unit’s region
setting/Resetting the base unit
1
(middle soft key) #136
2 MbN: Select the desired country. a
“Other” = countries except Czech and
Slovakia
“Česká rep.” = Czech
“Slovensko” = Slovakia
3 MbN: “Yes” a
a M N
Note:
R The following items will be deleted or reset
to their default settings:
– SMS settings (page 28)
– Answering system settings (page 27)
(KX-TG8561 series: page 3)
– Time adjustment
– Base unit ringer volume
(KX-TG8561 series: page 3)
– Base unit transmission power
– Privacy mode
– Base unit PIN
– Dial mode
– First ring
– All SMS messages
– Caller list
– Voice mail messages
– Call restrict
– Category name (Shared phonebook)
– Category ringer tone
R The following items will be retained:
– Display language
– Date and time
– Phonebook
– Handset name
– Repeater mode
– Recordings, including your greeting
message and caller messages
(KX-TG8561 series: page 3)
– Call screening (KX-TG8561 series:
page 3)
– Call barred list
R If you select the desired country in step 2,
the following default settings will be
changed for the selected country’s default
settings:
– Recall/flash time (page 31)
– Message centre 1 and 2 (page 28)
– SMS on/off (page 28)
R According to your country selection in step
2, the answering system announcement
language changes as follows (KX-TG8561
series: page 3):
– “Other” = English
– “Česká rep.” = Czech
– “Slovensko” = Slovak
R After changing the unit’s region setting/
resetting the base unit,
is displayed on
the handset momentarily. This is normal
and the handset can be used once
is
displayed.
Calendar/Schedule
You can program 20 schedule alarms for each
handset using the calendar. A schedule alarm
sounds at the set time for 1 minute. A text
memo can also be displayed for the schedule
alarm.
Important:
R Set the date and time beforehand
(page 15).
R If the unit is connected to a PBX system,
date information may not be properly
received. Set the PBX system to receive
the correct date information. Contact your
PBX supplier if necessary.
Adding a new entry
1
(middle soft key) a a
2 MbN: Select the desired date. a
R To move to another month in the
calendar, keep pressing MCN or MDN.
3
a MbN: “New Entry” a
4 Edit the date if necessary. a
5 Set the desired time. a
36
Programming
TG8551_61FX_(en-en)_0427_ver021.36 36 2012/04/27 20:24:46