Filter
Top Products
Useful Information
44
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
*1 KX-TG8021
Display message Cause/solution
Answer Sys. Full
*1
L Erase unnecessary messages (page 35).
Check Tel Line L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 12).
Error
*1
L Recording was too short. Try again.
Failed L Phonebook copy failed (page 22). Confirm the other
handset (the receiver) is in standby mode and try
again.
Incomplete L The receiver’s phonebook memory is full. Erase the
unnecessary phonebook entries from the other
handset (the receiver) and try again.
Memory Full L The phonebook memory is full. Erase unnecessary
entries (page 21).
L Message memory is full. Erase unnecessary
messages (page 35).
*1
L The maximum number of base units (4) is already
registered to the handset. Cancel unused base unit
registrations from the handset (page 30).
No link to base.
Reconnect AC
adaptor.
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset’s registration may have been cancelled.
Re-register the handset (page 29).
Use rechargeable
battery.
L A wrong type of batteries such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 5, 13.
You must first
subscribe to
Caller ID.
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
TG8011_8021BX(e).book Page 44 Monday, September 29, 2008 1:07 PM