Filter
Top Products
DECT repeater
Problem Cause/solution
The unit does not work. R When the indicators do not light, the AC adaptor is
not connected properly. Check the connections.
R When the indicators do not light green, move the
unit closer to the base unit.
R The repeater mode is “Off”. Set the repeater
mode to “On” (page 57).
R Registration may have been cancelled. Deregister
the unit, then re-register.
Deregister:
1 Unplug the AC adaptor, then press and hold
MPROGRAMN.
2 While pressing and holding MPROGRAMN,
re-connect the AC adaptor.
3 Keep holding to press MPROGRAMN for about
10 seconds until the
indicator stops
flashing and lights red. Then release
MPROGRAMN.
R The
and indicators light amber for a
moment then only the
indicator flashes
red.
R If the
indicator flashes green after
releasing MPROGRAMN, deregistration
failed. Deregisterthe unit again.
Re-register:
1 DECT repeater: Unplug the AC adaptor.
2 Base unit: Press and hold MLOCATORN for
about 5 second, until the registration tone
sounds.
R The next step must be completed within 90
seconds.
3 DECT repeater: Connect the AC adaptor,
then wait until the
indicator and indicator
light green.
4 Base unit: To stop the registration tone, press
MLOCATORN.
While talking using the
handset, sound cuts in and
out.
R The handset is out of range. Move the handset
closer to this unit.
69
Useful Information
TG76xxAZ(en)_0207_ver012.pdf 69 2012/02/07 15:34:49