Filter
Top Products
Changing the handset name
Each handset can be given a
customised name (“Bob”, “Kitchen”,
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is “No”. If you
select “Yes” without entering any
handset name, “Handset 1” to
“Handset 6” is displayed.
1 MMENUN#104
2 Enter the desired name (max. 10
characters; see the character table,
page 26).
R If not required, go to step 3.
3 MSAVEN
4 MbN: Select the desired setting. a
MSELECTN 2 times
5 MOFFN
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
when the unit receives a call from a
phone number stored in the call barred
list as unwanted (“Storing unwanted
callers”, page 37).
When a call is received, the unit rings for
a short time while the caller is being
identified. If the phone number matches
an entry in the call barred list:
– cellular calls are rejected.
– landline calls are disconnected after
the unit first sends out a busy tone to
the caller.
Important:
R When the unit receives a call from a
number that is stored in the call
barred list, the call is logged in the
caller list (page 42) with
after the
call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers
in the call barred list.
Important:
R You must store the phone number
with an area code in the call barred
list.
n From the caller list:
1 MFN CID
2 MbN: Select the entry to be barred.
3 MSAVEN
4 MbN: “Caller barred” a
MSELECTN
5 MbN: “Yes” a MSELECTN
6 Edit the phone number if
necessary (24 digits max.).
7 MSAVEN a MOFFN
n By entering phone numbers:
1 MMENUN#217 a MADDN
2 Enter the phone number (24
digits max.).
R To erase a digit, press
MCLEARN.
3 MSAVEN a MOFFN
Viewing/editing/erasing bar call
numbers
1 MMENUN#217
2 MbN: Select the desired entry.
R To exit, press MOFFN.
3 To edit a number:
MEDITN a Edit the phone number.
a MSAVEN a MOFFN
To erase a number:
MERASEN a MbN: “Yes” a
MSELECTN a MOFFN
Note:
R When editing, press the desired dial
key to add, MCLEARN to erase.
37
Programming
TG76xxAZ(en)_0207_ver012.pdf 37 2012/02/07 15:34:47