Filter
Top Products
Error messages
Display message Cause/solution
Base no power
o
r
No link. Re-connect
base AC adaptor.
or
No link.
R T
he handset has lost communication with the
base unit. Move closer to the base unit and try
again.
R Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
R The handset’s registration may have been
canceled. Re-register the handset (page 48).
R When “No link.” is displayed during a
power failure, place a handset on the base
unit to supply power to the base unit.
Busy
R N
o cellular phone is registered to the base
unit. Register a cellular phone (page 19).
R The called unit is in use.
R Other units are in use and the system is busy.
Try again later.
R The handset you are using is too far from the
base unit. Move closer and try again.
Call phone company for
y
our access #
R Y
ou have not stored the voice mail access
number. Store the number (page 64).
Check tel line
R T
he supplied telephone line cord has not been
connected yet or not connected properly.
Check the connections (page 10).
R If you do not connect the telephone line cord
and use only cellular lines, set the cellular line
only mode (page 21).
Error!!
R R
ecording was too short. Try again.
R Someone is using a cellular line or headset.
Try again later.
R The phonebook copy is incomplete (page 54).
The cellular phone is disconnected from the
base unit. Make sure that other Bluetooth
devices are not connected to the cellular
phone, and try again.
Failed
R A
lthough the unit tried to connect to the
cellular phone or headset, the connection has
been failed.
– Someone is using a cellular line or headset.
Try again later.
– Make sure that the cellular phone or
headset is not connected to other Bluetooth
devices.
For assistance, please visit http://www.panasonic.com/help
71
Useful Information