Blocking incoming calls without
p
hone number
You can reject a call when no phone
number is provided, such as a call just
showing “Out of area”.
1 MMENUN#240
2 MbN: Select the desired setting. a
MSAVEN a MOFFN
Viewing/editing/erasing call block
n
umbers
1 MMENUN#217
2 MbN: Select the desired entry.
R To exit, press MOFFN.
3 To edit a number:
MEDITN a Edit the phone number.
a MSAVEN a MOFFN
To erase a number:
MERASEN a MbN: “Yes” a
MSELECTN a MOFFN
Note:
R When editing, press the desired dial
key to add, MCLEARN to erase.
R When viewing, “Block w/o num” is
displayed if the blocking incoming
calls without phone number feature is
turned on. To turn the feature off:
MERASEN a MCN a MSAVEN a
MOFFN
Registering a unit
Operating additional units
Additional handsets
U
p to 6 handsets can be registered to
the base unit.
Important:
R See page 5 for information on the
available model.
Registering a handset to the
b
ase unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base
unit, re-register the handset.
1 Handset:
MMENUN#130
2 Base unit:
Press and hold MLOCATORN for
about 5 seconds until the
registration tone sounds.
R If all registered handsets start
ringing, press MLOCATORN again
to stop, then repeat this step.
R The next step must be completed
within 90 seconds.
3 Handset:
Press MOKN, then wait until a long
beep sounds.
Note:
R While registering, “Base in
registering” is displayed on all
registered handsets.
R When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Deregistering a handset
A
handset can cancel its own
registration to the base unit, or other
handsets registered to the same base
unit. This allows the handset to end its
wireless connection with the system.
1 MMENUN#131
R All handsets registered to the
base unit are displayed.
2 MbN: Select the handset you want to
cancel. a MSELECTN
3 MbN: “Yes” a MSELECTN
4 MOFFN
48
For assistance, please visit http://www.panasonic.com/help
Programming