Filter
Top Products
2 MbN:
Select the desired cellular
phone. a MSELECTN
R The call is transferred to the
handset.
Using the other line during a
c
onversation
You can handle a cellular call and a
landline call at the same time. When
another call is being received during a
conversation, the interrupt tone sounds
(page 43), and the 2nd caller’s
information is displayed if you subscribe
to Caller ID (page 49). You can
answer the 2nd call while holding the 1st
call.
Making/answering a cellular call
d
uring a conversation on the landline
1 Press MMENUN during a landline call.
2 MbN: “Hold” a MSELECTN
3 To make a 2nd call:
Dial the phone number. a
MCELLN
*1
a MbN: Select the desired
cellular phone. a MSELECTN
*1
The unit starts dialing when:
– only 1 cellular phone is
registered.
– a specific line is set to make
cellular calls (page 22).
To answer a 2nd call:
MCELLN
R To hold the 2nd call: MMENUN a
MbN: “Hold” a MSELECTN
4 To hang up the 2nd call and return
to the 1st call (landline call), press
MOFFN, then press M
N.
Making/answering a landline call
d
uring a conversation on a cellular line
1 Press MMENUN during a cellular call.
2 MbN: “Hold” a MSELECTN
3 T
o make a 2nd call:
Dial the phone number. a M
N
T
o answer a 2nd call:
M
N
R T
o hold the 2nd call: MMENUN a
MbN: “Hold” a MSELECTN
4 To hang up the 2nd call and return
to the 1st call (cellular call), press
MOFFN, then press MCELLN.
Power back-up
o
peration
Available for:
K
X-TG7641 series (page 3)
When a power failure occurs, the
c
harged handset temporarily supplies
power to the base unit (power back-up
mode). This allows you to make and
receive landline calls using a handset
during a power failure. The base unit will
not perform any other functions.
However, some functions such as Caller
ID and shared phonebook are available
only when using a handset other than
the handset supplying power to the base
unit. You can program “Power
failure” and the default setting is
“Auto” (page 44).
Important:
R If a handset is not placed on the base
unit when a power failure occurs,
“Base no power Press OFF” is
displayed. After pressing MOFFN on
the handset, place it on the base unit
to start power back-up mode.
R Power back-up mode will not work if
the battery level of the power
supplying handset is
or .
R D
o not lift the power supplying
handset from the base unit during
power back-up mode.
28
For assistance, please visit http://www.panasonic.com/help
Making/Answering Calls Using the Handset