Filter
Top Products
6 Enter the phone number or area code to
be restricted (8 digits max.). a
a
M
N
R To erase a restricted number, press
.
Changing the base unit PIN
(Personal Identification Number)
Important:
R If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, see
page 46.
1
#132
2 Enter the current 4-digit base unit PIN
(default: “0000”).
3 Enter the new 4-digit base unit PIN. a
a M N
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 5. If another handset model is
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1 Handset:
#130
2 Base unit:
Proceed with the operation for your
model.
n KX-TG6711 series: page 3
Press and hold M
N for about 5
seconds. (No registration tone)
n KX-TG6721 series: page 3
Press and hold M
N for about 5
seconds, until the registration tone
sounds.
R If all registered handsets start ringing,
press M
N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
3 Handset:
a Wait until “Base PIN” is
displayed. a Enter the base unit PIN
(default: “0000”). a
R If you forget your PIN, see page 46.
R When the handset has been registered
successfully,
is displayed.
Note:
R While registering, “Base in
registering” is displayed on all
registered handsets.
R When you purchase an additional handset,
refer to the additional handset’s installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
#131
R All handsets registered to the base unit
are displayed.
2 MbN: Select the handset you want to
cancel. a
3 MbN: “Yes” a
R A confirmation tone sounds.
R The handset does not beep when
cancelling its own registration.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
31
Programming
TG67xxE(en)_0802_ver102.pdf 31 2012/08/02 16:27:47