Filter
Top Products
Programming
30
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
L The next step must be completed
within 90 seconds.
3 Handset:
Wait until “Base PIN” is displayed.
i Enter the base unit PIN (default:
“0000”). i M
L If you forget your PIN, see page
46.
L When the handset has been
registered successfully, w is
displayed.
Note:
L While registering, “Base in
registering” is displayed on all
registered handsets.
L When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored to the
base unit. This allows the handset to end
its wireless connection with the system.
1 8 i {#}{1}{3}{1}
L All handsets registered to the
base unit are displayed.
2 {V}/{^}: Select the handset you
want to cancel. i M
3 {V}/{^}: “Yes” i M
L A confirmation tone sounds.
L The handset does not beep when
cancelling its own registration.
4 {ic }
Increasing the range of the
base unit
You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 4. Contact your
Panasonic dealer for details.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L Do not use more than one repeater at
a time.
Setting the repeater mode
1 8 i {#}{1}{3}{8}
2 {V}/{^}: Select the desired setting.
i M i {ic}
Note:
L After turning the repeater mode on or
off, _ is displayed on the handset
momentarily. This is normal and the
handset can be used once w is
displayed.
TG6561E(e).book Page 30 Tuesday, July 13, 2010 1:50 PM