Filter
Top Products
Useful Information
44
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the
batteries from the handset, and then insert the batteries into the handset again.
General use
Battery recharge
Problem Cause/solution
The handset does not turn
on even after installing
charged batteries.
L Place the handset on the base unit or charger to
turn on the handset.
The unit does not work. L Make sure the batteries are installed correctly
(page 8).
L Fully charge the batteries (page 8).
L Check the connections (page 8).
L Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
L The handset has not been registered to the base
unit. Register the handset (page 48).
I cannot hear a dial tone. L The base unit’s AC adaptor or telephone line cord
is not connected. Check the connections.
L Disconnect the base unit from the telephone line
and connect the line to a known working
telephone. If the working telephone operates
properly, contact our service personnel to have the
unit repaired. If the working telephone does not
operate properly, contact your service provider/
telephone company.
The indicator on the
handset flashes slowly.
L New messages have been recorded. Listen to the
new messages (page 33).
L New voice mail messages have been recorded.
Listen to the new voice mail messages (page 38).
Problem Cause/solution
The handset beeps and/or
d flashes.
L Battery charge is low. Fully charge the batteries
(page 8).
TG654xBX(e).book Page 44 Tuesday, June 28, 2011 10:16 AM