Filter
Top Products
Troubleshooting
76
General
Problem Cause & Remedy
The handset and/or base unit
does not work.
• Check the settings (p. 12–14).
• Check whether the dialing mode setting is
correct (p. 18).
• Fully charge the battery (p. 13).
• Clean the charge contacts and charge again
(p. 14).
• Check battery installation (p. 13).
• Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• The handset has not been registered to the
base unit. Register the handset (p. 70, steps
5 and 6).
• Re-install the battery (p. 13) and fully charge
it.
“Recharge battery” is
displayed, “3” flashes,
or the handset beeps
intermittently.
• Fully charge the battery (p. 13).
“Charge for 6 HRS” and
“
4” are displayed and the
handset does not work.
• The battery has been discharged. Fully
charge the battery (p. 14).
You charged the battery fully,
but “Recharge battery” is
still displayed and/or “
3”
continues to flash, or “Charge
for 6 HRS” and “
4” are
displayed.
• Clean the charge contacts and charge again
(p. 14).
•
The battery may need to be replaced. If you
install a new battery, fully charge it (p. 13, 14).
The CHARGE indicator does
not go out after the battery has
been charged.
• This is normal.
If you cannot solve your
problem
• Visit our website:
http://www.panasonic.com/support
• Contact us via the web at:
http://www.panasonic.com/contactinfo
• Call our customer call center at:
1-800-211-PANA(7262)