Filter
Top Products
Programming
23
For assistance, please visit http://www.panasonic.com/help
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Important:
L See page 5 for information on the
available model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base
unit, re-register the handset.
1 Handset:
{MENU}
2 {V}/{^}: “Initial setting” i
{OK}
3 {V}/{^}: “Registration” i
{OK}
4 {V}/{^}: “HS registration” i
{OK}
5 Base unit:
■ KX-TG4011 series: page 3
Press and hold {LOCATOR} for
about 5 seconds. (No registration
tone)
■ KX-TG4021/KX-TG4071 series:
page 3
Press and hold {LOCATOR} for
about 5 seconds until the
registration tone sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
6 Handset:
Press {OK}, then wait until a long
beep sounds.
Note:
L While registering, “Base in
registering mode” is displayed on
all registered handsets.
L When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored to the
base unit. This allows the handset to end
its wireless connection with the system.
1 {MENU}
2 {V}/{^}: “Initial setting” i
{OK}
3 {V}/{^}: “Registration” i
{OK}
4 {V}/{^}: “Deregistration” i
{OK}
5 {3}{3}{5} i {OK}
6 Select the handset(s) you want to
cancel by pressing the desired
handset number ({1}-{6}). i
{OK}
L The selected handset number(s)
flashes.
L To undo a selection, press the
handset number again. The
number stops flashing.
7 {V}/{^}: “Yes” i {OK}
8 {OFF}
TG401x.book Page 23 Wednesday, December 23, 2009 9:30 AM