Filter
Top Products
“Daily”
An alarm sounds daily at the set time.
Go to step 6.
5 Enter the desired date and month.
6 Set the desired time. a M N
7 MbN: Select the desired alarm tone. a
M
N
R We recommend selecting a different
ringer tone from the one used for
outside calls.
8 M N a M N
R When the alarm is set,
is displayed.
Note:
R To stop the alarm, lift the handset and
press M
N or place the handset on the
base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1 M
N
2 MbN: “Base Unit Setup” a M
N
3 MbN: “Repeater Mode” a M
N
4 MbN: Select the desired setting. a
M N a M N
Note:
R After turning the repeater mode on or off,
may flash on the handset momentarily.
This is normal and the handset can be used
once
stops flashing.
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1 Base unit:
Press and hold M
N for about 5 seconds.
(No registration tone)
R The next step must be completed
within 90 seconds.
2 DECT repeater:
Connect the AC adaptor, then wait until
the indicator and indicator light
green.
3 Base unit:
To exit the registration mode, press M
N.
19
Programming
TG2711_13SA(en)_0927_ver001.pdf 19 2012/09/27 12:18:21