Filter
Top Products
Main menu Sub-menu 1 Sub-menu 2
Base Unit Setup
*2
First Ring
*7
<On>
– –
Dial Mode
<Tone>
– 11
Recall/Flash
*8
<100 msec.>
– 14
Privacy Mode
*1,
*9
<Off>
– –
Base Unit PIN
– 29
Repeater Mode
<Off>
– 19
*1 KX-TG2713
*2 If you program these settings using one of the handsets, you do not need to program the
same item using another handset. (KX-TG2713)
*3 The ringer tone may continue to play for several seconds even if the caller has already hung
up. You may either hear a dial tone or no one on the line when you answer the call.
*4 The preset melodies in this product are used with permission of © 2011 Copyrights Vision
Inc.
*5 Turn this feature off if you prefer not to hear key tones while you are dialling or pressing any
keys, including confirmation tones and error tones.
*6 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*7 If you do not want the unit to ring before the caller information is received, set to “Off”.
(Caller ID subscribers only)
You can only remove the first ring if the unit rings two times or more by default, which
depends on your service provider/telephone company.
*8 The recall/flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
*9 To prevent other users from joining your conversations with outside callers, turn this feature
on.
Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
R Set the date and time beforehand
(page 11).
1 M
N
2 MbN: “Handset Setup” a M N
3 MbN: “Alarm” a M
N
4 MbN: Select the desired alarm option. a
M
N
“Off”
Turns alarm off. Go to step 8.
“Once”
An alarm sounds once at the set time.
18
Programming
TG2711_13SA(en)_0927_ver001.pdf 18 2012/09/27 12:18:21