Filter
Top Products
Programmable Settings
38
Programming via direct commands
You can also programme most features using “direct commands”—special codes that take
you directly to the feature you wish to programme and allow you to select the desired
setting. There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
1 Press {MENU}.
2 Enter the desired feature code (shown below).
3 Enter the desired setting code (shown below).
LThis step may vary depending on the feature being programmed.
4 Press {Save}.
5 Press {OFF} to exit programming mode.
Direct commands chart
Feature Feature code Setting code Page
Ringer volume {1} {1}{1}: Low {2}: Medium
{3}: High {0}: Off
page 32
Ringer tone {1} {2}{1}–{3}: Tone pattern 1–3
{4}–{7}: Melody pattern 1–4
page 33
Interrupt tone {1} {3}{1}: On {2}: 2 times {0}: Off page 33
Message play {2} – page 43
Date and time {4} Go to step 3 on page 16. page 16
Voice enhancer {5}{1}: On {0}: Off page 34
Dial lock {6} Go to step 3 on page 36. page 36
LCD contrast {0} {1}{1}–{6}: Level 1–6 page 34
Key tone {0} {2}{1}: On {0}: Off page 36
Auto talk {0} {3}{1}: On {0}: Off page 34
Set area code {0} {4} Go to step 4 on page 35 page 35
Set dial mode {0} {5} {1} – page 54
Set recall time {0} {5} {2}{1}: 700 ms {2}: 600 ms
{3}: 400 ms {4}: 300 ms
{5}: 250 ms {6}: 110 ms
{7}: 100 ms {8}: 90 ms
page 35
Set line mode {0} {5} {3}{1}: A {2}: B page 35
Ring count {0} {6} {1}{2}–{7}: 2–7 rings
{0}: Toll saver
page 47
TG2431AL_2432AL(e).book Page 38 Tuesday, March 15, 2005 6:37 PM