Filter
Top Products
61
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Problem
The handset display exits
the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
name and/or phone number.
You cannot page the
handset.
You cannot redial by
pressing (REDIAL/PAUSE).
“Rec
Remedy
•Do not pause for over 60 seconds while
searching.
•The line mode selection is incorrect. See
page 15.
•The caller requested not to send his/her
information. See page 28.
•The handset is too far from the base unit.
•The handset is engaged in an outside
call, viewing the Caller List/directory list.
Wait until the IN USE/CHARGE indicator
light goes out.
•If the last number dialed was more than
32 digits long, the number will not be
redialed correctly.
•The button has a double function as
either redial or pause. It will redial the
last number dialed if pressed at the
outset of a call (p. 22, 26). If another
number has been dialed first, it will
operate as a pause button (p. 52).
•Charge the battery fully (p. 12).
•Clean the charge contacts and charge
again (p. 13).
•Install a new battery (p. 57).
•This is normal.