Filter
Top Products
Base Unit Settings
21
Base unit settings
To customise the base unit using the handset:
1 {j/OK}
2 Press {^} or {V} to select “Base Unit Setup”. i {>}
3 Press {^} or {V} to select the desired item in the base unit settings menu. i
{>}
4 Press {^} or {V} to select the desired item in the sub-menu. i {>}
5 Press {^} or {V} to select the desired setting then press {>}.
L This step may vary depending on the feature being programmed.
L To exit the operation, press {ih}.
Note:
L The current item or setting is indicated by > on the display.
*1 Change the recall time, if necessary, depending on the requirements of your
service provider/telephone company or PBX.
The recall time depends on your telephone exchange or host PBX. Consult your
PBX supplier if necessary.
You can access your service provider/telephone company “Call Waiting” service
by having the recall time set at 100 ms, and then follow your service
provider/telephone company “Call Waiting” instructions to operate this service.
*2 If you change the PIN, please make note of your new PIN. The unit will not reveal
the PIN to you.
*3 If you forget your PIN, consult your nearest Panasonic service centre.
Menu Sub-menu Details (default setting)
Ringer Volume — For base unit (Medium)
Call Options Recall/Flash Recall time (“100 msec.”)
*1
Area Code page 22
Other Options Base Unit PIN Change base unit PIN (“0000”).
*2
– Enter the current 4-digit base unit
PIN.
*3
– Enter the new 4-digit base unit
PIN. i {>} i {ih}
Repeater Mode (“Off”): page 32
TG1855-1857AL(e-e).book Page 21 Thursday, July 12, 2007 5:31 PM