Filter
Top Products
Base Unit Settings
33
list to the phone number “123-456-7890”,
the unit dials “456-7890”.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4 Select “Call Options”, then press
{>}.
5 Select “ARS Settings”, then press
{>}.
6 Select “Area Code”, then press {>}.
7 Select an area code location (1 to 4),
then press {>}.
L If the location already contains an
area code, the code is displayed.
8 Enter an area code (5 digits max.), then
press {j/OK}.
9 Press {ih}.
Note:
L The use of this feature can prevent a
National Call from being dialled. E.g., in
the case of the South Island, the “03” will
be omitted and will therefore prevent a
National Call to other areas of the South
Island.
Setting call restriction
You can restrict the base unit or selected
handsets from dialling certain numbers. Up
to 6 phone numbers can be stored. Storing
area codes here will prevent the restricted
extensions (the base unit or selected
handsets) from dialling any phone number in
that area code.
Important:
L Call restriction can be set using handset 1
only. (To confirm which handset is handset
1, press {x} and {1} on the base unit.
Handset 1 will ring.)
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4 Select “Call Options”, then press
{>}.
5 Select “Call Restrict”, then press
{>}.
L The base unit extension number “0”
and the extension numbers of all
registered handsets are displayed.
6 Select the extensions which will be
restricted by pressing the desired
number.
L Flashing numbers indicate call
restriction is turned on for the
corresponding extension.
L To turn call restriction off for an
extension, press the dial key
corresponding to its extension
number. The number will stop flashing.
7 Press {j/OK}.
8 Select a memory location, then press
{>}.
L If the memory location already
contains a restricted number, the
number is displayed.
9 Enter the phone number or area code to
be restricted (8 digits max.), then press
{j/OK}.
L To erase a restricted number, press
{C/T}.
10 Press {ih}.
Turning call bar on/off
This feature prohibits making outside calls
with the base unit. When call bar is turned
on, only intercom calls and calls to
emergency numbers (page 32) can be
made. Call bar can be set independently for
the handset (page 28) and the base unit.